ARO RS25A–VLK 운영자 매뉴얼 - 페이지 6

{카테고리_이름} ARO RS25A–VLK에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ARO RS25A–VLK 8 페이지. Random orbital sanders 12,000 r. p. m.

THROTTLE DISASSEMBLY

– Remove eductor assembly (31). To remove, unthread upper

section, press in on tabs of lower section and pull assembly

from housing.

– Remove inlet adapter (9), releasing spring (8) and valve (7).

NOTE: Do not remove seat (6) unless damage is evident.

– To remove valve stem (2), remove roll pin (4) and lever (3).

THROTTLE ASSEMBLY

– Coat valve stem (2) with ARO 29665 spindle oil and assemble

into housing with hole in valve stem in line with housing to ac-

cept valve (7).

DISASSEMBLY/ASSEMBLY INSTRUCTIONS

– Assemble seat (6) into housing with rounded corners into

housing first.

– Coat valve (7) with ARO 29665 spindle oil and assemble into

housing, securing valve stem (2).

– Assemble spring (8) into housing.

– Assemble inlet adapter (9) to housing, securing throttle com-

ponents.

– Assemble lever (3) to housing, securing with roll pin (4).

– Assemble eductor assembly (31) to housing. To assemble, in-

sert tapered section of eductor assembly into housing while

aligning threaded section with housing. Using a wrench on

flats, tighten threaded section securely. Tabs will snap into

slots in housing.