Discovery Expedition D103X 사용 설명서 - 페이지 7

{카테고리_이름} Discovery Expedition D103X에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Discovery Expedition D103X 15 페이지. Self-powered am / fm / sw/noaa weather radio

페이지 인쇄
Discovery Expedition D103X 사용 설명서
Follow the manufacturer's instructions for charging the product and
do not charge longer than recommended. Unplug the charger
when the battery is charged.
Recycle Rechargeable Batteries
Recycle your old rechargeable batteries at one of the many collection sites in
the U.S. and Canada. To find the site nearest you,
visit www.call2recycle.org or call toll-free 1-877-2-RECYCLE.
B.BATTERY OPERATION
.
1 Remove the Battery Door on the back of the radio.
2.Following the polarity diagram shown in the battery compartment,
insert 3 'AAA' (UM-4) batteries (Not included) and replace the battery door.
3.When batteries were installed, the power of the build-in rechargeable
battery pack will be cut off after setting the Power Source Selector to
"BATT." (DRY CELL Battery) position.
IMPORTANT
: Be sure that the batteries are installed correctly.
Wrong polarity may damage the unit.
WARNING:
- Be sure that the batteries are installed correctly. Wrong polarity may damage the unit.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
- Only batteries of the same or equivalent type as recommend are to be used.
- If the unit is not to be used for an extended period of time, remove the battery. Any old or
leaking battery can cause damage to the unit and may void the warranty.
- Do not dispose of batteries in fire, batteries may explode or leak.
-
Do not try to recharge batteries not intended to be recharged; they can overheat, rupture
and leak(Follow battery manufacturer's directions).
C.
SOLAR POWER
1. Set the
Power Source Selector
2. Put the unit in the sunlight, make the solar panel of the unit is facing
the sun. If the sunlight is enough strong, the power light "IN" will be on,
the unit can work normally.
D. COMPUTER USB
1. Connect your computer's USB to the mini USB connector of the unit.
2. Turn on your computer and s
"
DYN position.
"

OPERATION

to DYN position.
POWER
OPERATION
et the
"
"
Power Source Selector
to
6