Cube Design Modular information desk 조립 설명서 - 페이지 3

{카테고리_이름} Cube Design Modular information desk에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cube Design Modular information desk 3 페이지.

Assembly manual for modular information desk

Step 6: For this step it is especially important to be

two people! Now place the top plate slightly diagonally

across the modules. Attach the bracket under the corner

of the top plate. If you have an extra top plate corner

then repeat step 6. NOTE: do not assemble the top plate

on the floor – stones or unevenness will scratch the

plate.

Step 8: Now the back plates must be installed. ATTEN-

TION! The order is important!

Place the back plate of the corner module front (1) by

using dowels and screws (4 x 35 mm).

Step 10: Insert the remaining back plates using dowels

and screws (4 x 35 mm).

Vadstedvej 212 | DK-8450 Hammel | Phone no.: +45 86 98 74 11 | www.cube-design.dk/en | [email protected]

Enjoy your new information desk!

Cube Design A/S

Step 7: Screw the top plate from the inside of the modules

– 3 screws (4.5 x 30mm) per module.

NOTE: If you have a free-standing infomation desk, you

must fix it to the wall or floor!

If you want to install power for e.g. lights/PC you can do

it now. Drill holes through the horizontal inner plates.

Step 9: Insert the loose dowels into the corner module

side (2) and then insert the associated back plate by

using dowels and screws (4 x 35 mm).

Step 11: Finally, put the enclosed plastic plugs into the

visible screw holes.

CUBE

D E S I G N