Cube Design RAW gable ends 조립 설명서 - 페이지 2

{카테고리_이름} Cube Design RAW gable ends에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cube Design RAW gable ends 3 페이지.

Assembly manual for RAW gable ends

Step 1: Position the inner side of the RAW gable end as shown.

Step 2: Mount each of the metal frames with the supplied screws and washers in the pre-drilled holes:

Place a washer between bracket and gable, and then mount a screw through the washer.

For easier assembling use a universal joint or flexible bit holder.

Step 3: Place the outer gable on a soft non-scratching surface. Take care not to scratch the surface.

Mount the supplied magnets with screws in the pre-drilled holes.

CUBE

D E S I G N

Cube Design A/S

Vadstedvej 212 | DK-8450 Hammel | Phone no.: +45 86 98 74 11 | www.cube-design.dk/en | [email protected]