Cubert S185 하드웨어 작동 매뉴얼 - 페이지 13

{카테고리_이름} Cubert S185에 대한 하드웨어 작동 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cubert S185 17 페이지.

If every connector is connected correctly, the camera system will power-up. This process may take

up to 2 minutes. For control: During the power-on process, the yellow and orange light of the

camera will start blinking.

The camera system is now fully operational. In order to turn off the system, press deep the on/off

("fitlet")-button of the Cubert Mini-PC server. Disconnect the power supply afterwards.

If not connecting to the Cubert Mini-PC server, but to a custom client PC, the respective NIC's

TCP/IPv4 properties must be configured according to the following table. Upon using an USB/Ex-

pressCard-NIC, use the Eth1 Port (192.168.100.100) for this device.

Camera IP

Ethernet

192.168.100.100

Ethernet 2

192.168.200.100

6 Maintenance of the camera

NEVER CHANGE APERTURE AND FOCUS ON THE CAMERA, IT WILL DESTROY THE CALIBRATION

Dabs, dust and other foreign particles may influence the image capturing process. Thus, you should

never touch the objective lens or the tilted mirror (if applicable).

For cleaning the front-lens, do not use non-certified optic cleaners, because on any damage on

coating will ruin the calibration. Do not press too firmly on the objective lens or the tilting mirror, as

they might be scratched and/or damaged which will result in malfunction of the system.

The camera case can be cleaned with a soft and dry cloth.

We recommend an annual service maintenance interval for re-calibration of the Hyper-Spectral

PC IP

192.168.100.13

192.168.200.13

camera. Please contact Cubert support.

Netmask

255.255.255.0