CubeWORKS CubiSens TS100 사용자 설명서 - 페이지 5

{카테고리_이름} CubeWORKS CubiSens TS100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CubeWORKS CubiSens TS100 15 페이지. Wireless temperature sensor

2. User System Requirements

For proper operation of the TS100 Communication Kit, user needs access to a Windows computer with 2

available USB ports. Details on minimum system requirements is shown below.

Operating System

Memory

Processor

Software Framework

Storage

Ports

1. Screw in the antenna to the CSG100-A9 CubiSens™ Gateway as shown in Figure 5.

2. Connect the 5V power adapter to the CSG100-A9 Gateway and plug it into a power outlet.

3. Connect the ethernet cable to the CSG100-A9 Gateway and to the ethernet-to-USB adapter.

4. Connect the ethernet-to-USB adapter into a computer's USB port.

5. Verify that the Power light is lit on the gateway, and that the Activity light is blinking.

6. Connect the CubiSens

is connected to with the provided micro-USB cable.

7. Verify that two blue LEDs light up in the programmer, and that one starts blinking, as shown in

Figure 5.

8. The kit is now ready for ethernet configuration and software installation.

Note: The gateway will become warm to the touch. Please keep the top and sides clear when it is powered

to allow proper ventillation.

Minimum User System Requirements

Figure 5. TS100 Communications Kit Hardware Connections

Optical Programmer to the same computer that the CSG100-A9 Gateway

CubiSens

Windows 7, 8, 10

1GB

1GHz

Microsoft .NET 4.7.2

500MB available disk space

2 available USB 2.0 (or higher) ports

TS100 User Manual

v1.7

Page 5 / 15