3D innovations DeskCycle2 사용자 설명서 - 페이지 11

{카테고리_이름} 3D innovations DeskCycle2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D innovations DeskCycle2 16 페이지.

Some people prefer to use the bike without the pedals straps. When the pedal straps are removed the

top of the pedal will always face up. This makes it easier to quickly place your feet on the pedals.

•

The top and bottom pedal halves snap together.

•

You can remove the straps whether the pedals are attached to

the bike or not.

Follow the steps below to remove the straps.

Step 1:

Insert a flat screwdriver into one of the slots. Rotate the

screwdriver downward to pry the halves apart. You should hear

a slight pop as one of the snap-fittings comes loose. There are 4

snap-fittings holding the pedals together.

Step 2:

Insert the screwdriver into the 2nd slot and repeat step 1.

Step 3:

Now insert the screwdriver into the gap on the side of the pedal.

Twist the screwdriver to pry the halves apart.

Step 4:

Slide the screwdriver to the right and twist again. Repeat until you

hear the snap-fitting release.

Repeat steps 3 and 4 on the other side of the pedal.

At this point you should be able to pull the halves apart.

Step 5:

The straps are pressed onto the posts as shown in the picture on

the right. Just pull up on the ends of the straps to remove them.

Step 6:

Press the halves back together.

Removing the Pedal Straps

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6