3D innovations DeskCycle2 사용자 설명서 - 페이지 15

{카테고리_이름} 3D innovations DeskCycle2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D innovations DeskCycle2 16 페이지.

PROBLEM: I CAN'T INSTALL ONE OR BOTH OF THE PEDALS

Are You Installing The Correct Pedal Into The Correct Pedal Arm?

Note that there is a left pedal and a right pedal. They are different from each other.

•

The Left pedal is marked with an L.

And the Right pedal is marked with an R.

•

The marking is on the end of the pedal shaft.

•

The pedal arms are also marked with a label.

Make sure you install the left pedal into the left pedal arm and the right pedal into the right pedal arm.

See the "Assembly" section in this manual for more details.

Are You Screwing The Pedals In Correctly?

•

Make sure the pedal is straight when you screw it in. The pedals should not be screwed in at an

angle. This will cause cross-threading which can damage the threads.

•

Rotate the shaft with your fingers to get the threads started.

•

If you can't get the thread started with your fingers then it is cross threaded. Unscrew the pedal,

make sure the pedal is straight, and then try again. Contact us if you still have problems.

•

The right pedal screws in clockwise

•

The left pedal screws in counter-clockwise.

If you are still having problems installing the pedals, contact us for assistance.

PROBLEM: THE DESKCYCLE MAKES NOISE WHEN I PEDAL IT

DeskCycles are designed to be quiet. We guarantee it, and it is covered under the warranty.

Try each solution below to see if it solves your problem. If the noise is still there after you've tried

these solutions, contact us so that we can help you solve the problem.

Solution 1: Tighten The Pedals

Make the pedals as tight as possible using a 15mm wrench. See the Assembly section for instructions.

Solution 2: Tighten The Nuts That Attach The Legs

Each leg is attached to the bike using two nuts. You can use a 13mm wrench to tighten these nuts. Be

careful not to over-tighten the nuts.

For more troubleshooting topics see our troubleshooting page at

Troubleshooting

DeskCycle.com