Cubicon 3DP-110F 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} Cubicon 3DP-110F에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cubicon 3DP-110F 12 페이지.

⑦ Remove the package and tape. Set the horizontal levelness of the printer by adjusting the feet, while referring

to the inclinometer.

* The driving part is fixed with packaging material only, without using a cable tie, in order to

prevent potential problems when the printer is operated. Please be careful not to damage

the part when removing the internal packaging material.

* The extruder-driven cable and the Teflon tube are located near the extruder fixing

packaging material. Since the extruder-connected cable and Teflon tube are the moving

path of the filament, they should be handled carefully to avoid damage from being

excessively pulled, bent or pressed.

Mounting of Clean Filter

① Pull out the clean filter case from the printer body.

③ Insert the clean filter case into the printer body.

Mount the clean filter in the correct position inside the case. If it is positioned incorrectly, the

filter performance will degrade and cause a malfunction of the ventilation fan.

This document is the Quick Start Guide (141020,kr), and is subject to change without notice when necessary for

product improvements. HyVISION System does not take the responsibility for loss caused by any error in the

document or provisions and use of this document.

Unpacking and Installation (2/4)

Inclinometer

② Place the clean filter inside the case.

Position the clean filter carefully.