Dish Network DE12 설명 및 설치 매뉴얼 - 페이지 4
{카테고리_이름} Dish Network DE12에 대한 설명 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dish Network DE12 13 페이지. Dish network receiver front panel description and installation
페이지 인쇄
Chapter 2
Receiver Description and Installation
Page 12
Remote Control Batteries
The remote control comes with AAA batteries, which need to be
installed when you first receive your system. When you replace
old batteries, you should replace all of the batteries. Use
batteries of the same kind, for example, alkaline or carbon zinc;
and don't mix batteries of different kinds. Alkaline batteries last
longer than carbon zinc.
1. Press down on the top of the battery cover and push in the
direction of the arrow. The cover will snap off.
2. Take out all of the old batteries.
3. Put the new batteries in. Make sure you match the plus ("+")
ends with the plus markings on the battery case.
4. Fit the battery cover's bottom tab back into the slot at the bottom of the
battery case, and slide the cover back into place.
On Screen Low Remote Battery Warning
When you see a low battery warning message below the Program
Banner
the batteries in your remote control are weak and need to be
,
replaced.