Dish Network DuoDVR 625 원격 제어 설정 - 페이지 15

{카테고리_이름} Dish Network DuoDVR 625에 대한 원격 제어 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Dish Network DuoDVR 625 17 페이지. Dish network remote control setup guide
Dish Network DuoDVR 625에 대해서도 마찬가지입니다: 시작하기 (2 페이지)

페이지 인쇄

222.book Page 71 Tuesday, July 25, 2006 1:30 PM

•

IPS

If using a specific channel for TV2 (for example, channel 60), TV2's remote control

must be programmed with a TV2 channel/input before you can use RECOVER.

Place the channel sticker on the remote TV and write down the channel you use to

watch DISH Network programming. The stickers are inside the front cover of this

guide.

If you don't want to accidentally change channels on your TV or VCR, try

programming the remote control in Limited Mode as described on page 62.

Make sure you have a UHF antenna connected so you can use Remote Control 2.

See page 15 for instructions.

UESTIONS

My remote doesn't control my receiver or other components. What should I do?

–

Put the remote control is in the correct mode (page 62).

–

Check the batteries (page 15).

–

Check the remote control address (pages 59 and 65).

–

Check the UHF antenna (page 15).

–

Adjust the UHF antenna (page 60).

Why does my receiver change channels or display menus at random? Your

neighbor may have their remote control set on the same address. Change the

address on your remote control and receiver as described on page 58. If that doesn't

help, you may have to install a UHF attenuator as described on page 61.

Remote Controls

Tips