AERF WIRELESSBAND 2 OSE 사용 설명서 - 페이지 2

{카테고리_이름} AERF WIRELESSBAND 2 OSE에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AERF WIRELESSBAND 2 OSE 8 페이지.

페이지 인쇄
AERF WIRELESSBAND 2 OSE 사용 설명서
EN
4. SLEEPING MODE SETTING UP FOR OPTICAL LOW POWER SAFETY EDGE
Sleeping mode disconnects the Optical Safety Edge (OSE) power supply from transmitter when no signal is received in 11-12 input.
When signal is detected, connects the power supply during the door manouvre. There are 2 sleeping mode configurations
dependinig on control unit output (Pulse or level signal) and without* sleeping mode.
WARNING!!
*Sleeping mode is highly recommended due to optimize energy consumption when using an optical safety edge.
If skip sleeping mode, battery life will decrease to 6 months.
Desired transmitter and receiver options must be set before code memorisation for proper use.
4.1 PULSE FROM CONTROL UNIT
1
2
3
4
5
6
VCC1
VCC2
OUTPUT 1
a
~ -
~
+/
/
Transistor output
SAFETY
Ground
4.1.1 OSE POWER SUPPLY TIME PROGRAMMING PROCESS (only with OPTION 4 & 5 - ON)
1.5s
PROG.
PRESS
1 X
RECEIVER
BEEP
1.5s
PROG.
PROG.
PRESS
RELEASE
RECEIVER
RECEIVER
KIT WIRELESSBAND 2 OSE
Signal
type
Receiver
7
8
9
10
11
12
TEST
TEST RELAY 2 /
OUTPUT 2
RELAY 1
INHIBITOR
b
c
Relay output
b
c
a
b
LED ON
PROG.
RELEASE
TRANSMITTERS
RECEIVER
PROG. MODE
SAVE & QUIT
Pulse
Level
point 4.1
point 4.2
- Pulse signal before each maneuvres is needed.
- For the control unit pulse output, must program
the optical safety edge power supply time (equal
or more than door manoeuver time)(follow point
4.1.1).
OPTION 5 ON
ON
5
1
2
3
4
5
SELECT
ENABLE
SLEEPING MODE
SLEEPING
TYPE = PULSE
MODE
1.5s
PROG.
PROG.
PRESS
RELEASE
RECEIVER
RECEIVER
30" by default
OPTION 3
ON
OPTION 4 ON
5
ON
3
1
2
4
5
5
1
2
3
4
5
ON
5
1
3
2
4
5
SELECT PULSE TYPE
FROM CONTROL UNIT
FLASH
LED FLASHES
PROG. MODE
RECORD TIME*
POWER SUPPLY
TIME
* Record the optical
safety edge power
supply time. (Equal
or more than door
operation time).
2 - 8