Dish Network DuoDVR 625 원격 제어 설정 - 페이지 8

{카테고리_이름} Dish Network DuoDVR 625에 대한 원격 제어 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Dish Network DuoDVR 625 17 페이지. Dish network remote control setup guide
Dish Network DuoDVR 625에 대해서도 마찬가지입니다: 시작하기 (2 페이지)

페이지 인쇄

222.book Page 64 Tuesday, July 25, 2006 1:30 PM

Chapter 9

Controlling Other Components

If the code doesn't work, repeat steps 3

through 9 with another device code

from the tables.

If you can't find a code that works try,

Setting Up Using Device Codes Scan

that follows.

Setting Up Using Device Codes Scan

If the code for your device is not listed in the tables starting on page 116, use this

procedure to scan the remote control's memory for the device code. In the instructions

below, the column on the left contains the instructions and the column on the right

provides additional information.

Turn the device on.

Press and hold the mode button until

all the other mode buttons light up, and

then let go of the button. The mode

button flashes.

For AUX mode only. Press 0 for a

second TV, or 1 for a second VCR,

or 2 for a tuner, or amplifier. Then press

the STAR (*) button.

Press POWER.

Instructions

Additional Information

Try every code listed for your brand until one

works for your device.

Additional Information

Use the device's front panel buttons or its

remote control.

For example, hold TV for a TV until all of the

other mode buttons light. When you let go, TV

will flash.

This step is for programming which kind of

device that should be programmed in AUX

mode. If you're not programming in AUX mode,

skip to step 4.

This puts your remote in the scan mode.