Abbot & Ashby 804533 운영 매뉴얼 - 페이지 7

{카테고리_이름} Abbot & Ashby 804533에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Abbot & Ashby 804533 8 페이지. 8” industrial bench grinder with wire wheel

ATBG600/8WBM Operating Manual

WARNING!

Do not use bench grinders in areas where there is a risk of explosion or fire from

combustible materials, flammable liquids, paint, varnish, petrol etc. flammable gases and

dust of an explosive nature. As a precaution it is recommended that you consult an expert

on a suitable fire extinguisher and its use.The metal particles (sparks) which are produced

during grinding are hot and could ignite any combustible material in the vicinity of the

operation.

GETTING STARTED

ACCESSORIES

The bench grinder is supplied with the following accessories:

2 eye shields with mounting brackets and 2 tool rests

CAUTION. Always ensure that the bench grinder is switched off and plug is removed from

the power point before making any adjustments.

To fit the eye shields locate the nut, screw and washers provided through the slot in the eye

shield and hole on the grinding wheel guard and finger tighten. Position the eye shield so it

does not come in to contact with the grinding wheel. Tighten the nut and screw to secure the

eye shield in place.

Attach the tool rests using the bolts and securing knobs provided and adjust to the correct

position. The gap between the tool rest and grinding wheel should be set to 2mm.

BENCH MOUNTING

The Grinder can be secured with screws or nuts and bolts. Locate the mounting holes. The

length of the bolts or screws will depend on the thickness of the bench. Where a steel

bench is used it is best to mount the grinder on to a board, then attach the board to the

bench, this will also minimise vibration.

Before connecting to the power supply rotate the wheel by hand to ensure that it is running

free from obstruction. Connect to the mains supply and press the rocker switch to the ON

position (l). To stop the machine simply press the rocker switch to the OFF position (o).

Regularly check that all the fixing screws are tight. They may vibrate loose over time.