CubuSynth ADSR 빌드 매뉴얼 - 페이지 3
{카테고리_이름} CubuSynth ADSR에 대한 빌드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CubuSynth ADSR 10 페이지. Envelope generator with looping mode, time and level control
페이지 인쇄CubuSynth ADSR - Build Guide
STEP 1
1N4148 x6
As always start with the smallest components. In this case it's the
1N4148 Diodes. Make sure the black line on the diode is lined up with
the white stripe on the PCB.
Bend the solder legs outwards, so it doesn't fall when turning around
the board. (same for STEP 2-10)
STEP 3
330R resistors x2
When all diodes are soldered, look for the 330ohm resistors and put
them in place.
Orientation on all resistors doesn't matter.
Page 3
BUILD GUIDE
STEP 2
1N400X* x2
identify the 1N400X* diodes and put them in place. Again orientation is
Important. These are the reverse voltage protection diodes. The white
line on the diode has to line up with the stripe on the PCB silkscreen.
Turn board around and solder everything in place.
*can be any from 1N4001 to 4007 or 1N5819 (marked as 1N4001 on the
PCB)
PCB V2.1 Aug 2021