CubuSynth Dual CS-20 VCF 빌드 매뉴얼 - 페이지 9
{카테고리_이름} CubuSynth Dual CS-20 VCF에 대한 빌드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CubuSynth Dual CS-20 VCF 16 페이지. Dual / stereo multimode vcf with self-oscillating resonance and intuitive routing and cv modulation matrix
CubuSynth Dual CS-20 VCF에 대해서도 마찬가지입니다: 매뉴얼 (9 페이지)
페이지 인쇄CubuSynth Dual CS-20 VCF - Build Guide
STEP 11 (Main PCB)
Power header
1
EURORACK10
Turn around the board and place the Pin Header for Power like shown.
Orientation of the Power Header is very important to be able to insert the power cable the
correct way.
Put some tape, to hold it in place while soldering from the other side or push it against the PCB
with your fingers while soldering the first Pin. Be careful to not touch the one Pin you are
soldering, it gets very hot!
STEP 12 (Main PCB)
10uf Electrolytic capacitors
2
10u
Place the two 10uf capacitors on the bottom of the
PCB, with the white/grey line on the capacitor
facing towards the white mark on the PCB. The
longer leg of the capacitor goes through the hole
marked with "+"
Page 9
SV1
C10,C9
PCB V1.4 Mar 2023