CubuSynth Engine V2 빌드 매뉴얼 - 페이지 5

{카테고리_이름} CubuSynth Engine V2에 대한 빌드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CubuSynth Engine V2 11 페이지. Dual complex vco with wave shaping and modulation features

페이지 인쇄

CubuSynth Engine V2 - Build Guide

SMD-PCB V1.1 Jul 2023

STEP 4 (Switch PCB)

Take the small Switch adapter PCB and the 4 position slide switch. Place the switch on the side

that says SW3. It is recommended to use a helping hand to secure them together while soldering.

When soldered, cut the solder legs flush with the PCB to avoid shorting them later!

Then put it aside for later use.

STEP 5 (Switch PCB)

Male pin headers

Place the 1x6 Male pin headers on the PCB, with the longer pins facing down. Then fit the Switch

with its adapter PCB on top, like shown below. Solder from top (the side of the switch) but wait

with soldering the other side.

Then take it out and leave it for later.

HDR-M-2.54_1x6

J28,J31

Page 5