Acoustech H-100II 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Acoustech H-100II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acoustech H-100II 12 페이지. 12 inch powered subwoofer

SUBWOOFER CONNECTION - METHOD A

Connecting to Receivers with a SUBWOOFER or LFE Output Jack

All Dolby Digital, DTS, THX, and Bass Management equipped receivers have a low level SUBWOOFER or LFE output jack. If you

have this, you will use the METHOD A connection as shown below in Drawing C. This is the recommended and easiest connection.

If your receiver does not have a low level SUBWOOFER or LFE output jack, you will use METHOD B (Drawing D) on Page 7 to

connect your subwoofer to the receiver.

For this connection, you will need a mono interconnect cable with a male RCA jack on both ends. This can be purchased at the

majority of electronics and audio stores. Make sure the length of your cable is long enough to reach from your receiver to your sub-

woofer location. The cable should lie flat with a little bit of slack to give some placement flexibility.

WIRELESS HOOKUP

- If you prefer a wireless connection rather than using a subwoofer cable, you can connect your

H-100II wirelessly to your digital receiver with a BIC WTR-SYS kit. You can also add an unlimited amount of wireless H-100II

subs to your system by adding BIC W-Receivers. Please contact BIC sales at 877-558-4242, ext. #1 for more information.

HOOKUP STEPS

DRAWING C

1. IMPORTANT: Make sure that ALL stereo

Connecting with a Subwoofer or LFE output jack.

system components including the subwoofer

are turned OFF before proceeding.

2. Locate the SUBWOOFER or LFE output

connector on the rear of your receiver and

connect one end of the RCA cable to it.

3. Route the RCA cable to the subwoofer lo-

cation (trying to minimize areas where it

may be stepped on). Connect the other end

of the cable directly to the SUB IN.

4. Connect your main (and surround speak-

ers if applicable) to the receiver according

to the receivers owner manual.

5. Connect the included power cord to the

POWER INPUT (#1) on the back of your

H-100II. Then connect its plug to an AC

outlet ONLY. Since your H-100II draws a

moderately high amount of current, we do

not recommend plugging it into a "conve-

nience" outlet (switched or unswitched)

found on the back of receivers and other

stereo components.

6. Set the CROSSOVER FROM DIGITAL

RECEIVER OR SUB SWITCH (#2) to the

"Digital Receiver" position (on left). This will

enable you to set the crossover from your

digital receiver and disable the CROSS-

OVER FREQUENCY CONTROL (#3) on

the back of your H-100II (also see Page 5,

#5). Refer to your receiver's owner manual

for instructions on how to set your crossover.

You also need to make sure the SUB-

WOOFER ON setting is set in your receiver.

Otherwise, the receiver will send no signals

to the subwoofer and there will be no sound.

7. Set the PHASE SWITCH (#4) to 0°.

You will later need to follow instructions on

Page 5, #3 for room settings.

8. You are now ready to turn your POWER

SWITCH (#5) on and enjoy the deep bass

you have been waiting for. You can learn

more about the "auto" feature on this switch

on Page 5, #2.

9. See Page 9 for "Initial Listening Test".