Dish Network DuoDVR ViP 622 사용자 설명서 - 페이지 2

{카테고리_이름} Dish Network DuoDVR ViP 622에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dish Network DuoDVR ViP 622 17 페이지. Receiver and remote controls
Dish Network DuoDVR ViP 622에 대해서도 마찬가지입니다: 원격 제어 설정 (17 페이지)

페이지 인쇄

Chapter 2

Satellite Receiver Overview

This section gives you an overview of your DISH Network satellite TV receiver system.

Satellite Receiver

The ViP622 DVR and ViP722 DVR are dual-tuner satellite receivers with digital video recorders.

With either receiver you can view/record standard-definition (SD) and

DISH Network programming on two TVs or view/record over-the-air digital/HD broadcasts on the

nearby HDTV.

•

Nearby TV (TV1)—Connect to an HDTV to view SD and HD DISH Network programming and

over-the-air digital/HD broadcasts. Programming from the receiver is delivered to the nearby

TV using short audio/video cables.

•

Remote TV(s) (TV2)—Connect to an SDTV to view SD and down-converted HD broadcasts.

Programming from the receiver is usually delivered to the remote TV(s) using existing in-home

coaxial cable.

Remote Controls

Two remote controls come with your receiver:

•

Remote Control 1 - An Infrared (IR) remote to control programming for the nearby TV (TV1).

This remote control is labeled with a green number 1, which matches similar markings on the

receiver output connections and the menus for the nearby TV.

•

Remote Control 2 - An Ultra-High Frequency Pro (UHF Pro) remote to control programming at

a remote TV (TV2). This remote control is labeled with a blue number 2, which matches similar

markings on the receiver output connections and the menus for the remote TV. Be sure to set

up the remote control to operate the receiver (see page 72).

Dual and Single Modes

Your satellite receiver includes two modes of operation: Dual and Single. These modes increase

your entertainment options because you'll be able to choose how you watch and record your favor-

ite programs.

Dual Mode

While in Dual Mode, you can use this dual-tuner satellite receiver to watch different programming

in two separate locations:

•

Nearby TV—Programming from the receiver is delivered to the TV near the receiver using

short audio/video cables and is controlled using Remote Control 1. The nearby TV is also

referred to as "TV1."

•

Remote TV—Programming from the receiver is delivered to a TV located in another room

using existing in-home coaxial cable and is controlled using Remote Control 2. The video

displayed on the remote TV is always in standard definition (SD). High-definition stellite

high-definition (HD)