CubuSynth Dual CS-20 VCF 빌드 매뉴얼 - 페이지 13

{카테고리_이름} CubuSynth Dual CS-20 VCF에 대한 빌드 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CubuSynth Dual CS-20 VCF 16 페이지. Dual / stereo multimode vcf with self-oscillating resonance and intuitive routing and cv modulation matrix
CubuSynth Dual CS-20 VCF에 대해서도 마찬가지입니다: 매뉴얼 (9 페이지)

페이지 인쇄

CubuSynth Dual CS-20 VCF - Build Guide

STEP 17 (control PCB)

Controls

B100K Pot

B100K Tall Trimmer

PJ-301M

First, place fix the M3 spacer, like shown in the picture.

Now take the Potentiometers and jacks and put them in

place as marked on the PCB but don't solder yet.

In the picture below you can see the placement.

When everything is in place, take the front panel and

put it on top, so all controls go into each corresponding hole of the panel. "wiggle" the front

panel into place and make sure everything fits well.

Fit all nuts to the Potentiometers and the Jacks.

Be careful when turning the board around, so that all the components stay in place.

Then solder everything.

Page 13

CUTOFF,LP-HP-1,LP-HP-2,RESO

CV1A,CV2A,RCV1A,RCV2A,

CV1,CV2,IN1,IN2,OUT1,OUT2,RCV1,RCV2,V/O1

PCB V1.4 Mar 2023