3D Platform WorkSeries 200 Series 빠른 참조 매뉴얼 - 페이지 3

{카테고리_이름} 3D Platform WorkSeries 200 Series에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Platform WorkSeries 200 Series 9 페이지.

3D Platform

Introduction

This quick start guide introduces the basic controls and functionality provided with the WorkSeries controller. This

reference guide is meant only as a secondary reference. This guide should be used in conjunction with the 3D Platform

WorkSeries User Manual, which can be downloaded from our website at www.3dplatform.com.

From the Touch Screen

1. Select the "Console" tab at the bottom of the touch screen.

2. Select the keyboard symbol at the top of the touch screen.

3. Type in the g-code or m-code you wish to execute.

4. Press the enter key on the touch screen keyboard.

5. Read the feedback message corresponding to the command executed (if applicable).

6. Verify the result corresponds to the expected result of the command sent.

From the Web Interface

1. Locate the "G-Code Console" at the left side of the web interface.

2. Type the command to be executed into the command line and press enter.

3. Read the feedback message corresponding to the command executed (if applicable).

4. Verify the result corresponds to the expected result of the command sent.

Note: For a list of g-codes and m-codes supported by our controller refer to our support page at support.3dplatform.com.

Wi-Fi Connection Setup

1. With the control box turned on, select the "Console" tab on the touch screen.

2. Select the keyboard symbol at the top of the touch screen.

3. Type

M552 S0

into the keyboard to turn off Wi-Fi connection.

4. Press the Enter symbol to run the command (Repeat this step for following commands).

5. Type

M552 S1

into the keyboard to turn on Wi-Fi connection.

6. On your computer or mobile device, open the Wi-Fi (network) connections list.

7. Select "Duet Wi-Fi" and connect.

Note: If network does not appear, enter M552 S2 in Console on touch screen.

8. Open a web browser and type the IP address 0.0.0.0 into the browser bar.

Note: If 0.0.0.0 does not work, try 192.168.1.1

9. In the menu, select your local Wi-Fi network and enter the network password.

10. You should receive an "All Done!" message.

11. Disconnect your PC or mobile device from the "Duet Wi-Fi" network.

12. Power cycle the controller to complete the setup (Black Button, followed by Green Button).

3DP-DOC-006 (11-2017)

WorkSeries Quick Reference Guide

www.3dplatform.com

Revision: B

pg. 2 of 8