Abbott FreeStyle Libre 빠른 시작 매뉴얼
{카테고리_이름} Abbott FreeStyle Libre에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Abbott FreeStyle Libre 2 페이지. Reader
Abbott FreeStyle Libre에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (18 페이지), 소프트웨어 업데이트 (3 페이지), 올바른 사용 지침 (6 페이지), 빠른 시작 매뉴얼 (5 페이지)
FLASH GLUCOSE MONITORING SYSTEM
Quick Start Guide
●
1
Assemble and Apply Sensor to the back of your upper arm
STEP 1
Select site on back of upper arm.
Do not use other sites as these are not
approved and may result in inaccurate
glucose readings.
Avoid scars, moles, stretch
Note:
marks, lumps, and insulin injection
sites. To prevent skin irritation, rotate
sites between applications.
STEP 4
Line up dark mark on Sensor
Applicator with dark mark
on Sensor Pack. On a hard
surface, press down firmly
on Sensor Applicator until it
comes to a stop.
STEP 7
Place Sensor Applicator over site
and push down firmly to apply
Sensor.
Do not push down on
CAUTION:
Sensor Applicator until placed
over prepared site to prevent
unintended results or injury.
Setup Overview
Refer to your User's Manual for full system instructions and information.
Reader
USB Port
Sensor
Pack
Codes on labels
must match
STEP 2
Clean site with alcohol wipe. Allow
site to dry before proceeding.
STEP 5
Lift Sensor Applicator out of
Sensor Pack.
STEP 8
Sensor
Gently pull Sensor Applicator
away from your body.
●
1
Touchscreen
Home Button
●
2
Sensor
Applicator
You can check your glucose whenever
Sensor Applicator
Aplicador del sensor
CODE
XXX
you want for up to 10 days
XXXXXXXXXXX
YYYY-MM-DD
Peel lid completely off Sensor Pack.
Unscrew cap from Sensor Applicator.
CAUTION:
match on Sensor Pack and
Sensor Applicator or glucose
readings will be incorrect.
Assemble and Apply Sensor
to the back of your upper arm
Start new Sensor with Reader
Wait 12 hours
for start-up
STEP 3
Cap
Lid
Sensor codes must
Sensor Pack | Envase del sensor
Customer Service | Atención al cliente
CODE
STEP 6
Sensor Applicator is ready to
apply Sensor.
Sensor Applicator
CAUTION:
now contains a needle. Do not
touch inside Sensor Applicator
or put it back into Sensor Pack.
STEP 9
Make sure Sensor is secure.
Discard used Sensor Applicator
and Sensor Pack according to
local regulations.
1-855-632-8658
XXX
XXXXXXXXXXX
YYYY-MM-DD