Aroma360 Mini360 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Aroma360 Mini360에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aroma360 Mini360 3 페이지.

페이지 인쇄

SETTING UP YOUR AROMA360 DIFFUSER

1 To open your Aroma360 diffuser rotate the

upper half of your device in a

counterclockwise motion, while firmly

holding the bottom half.

2 Remove the empty Aroma360 bottle from

the diffuser by turning it clockwise. The

empty bottle is included in your equipment

to be used in the cleaning process of your

diffuser.

Please refer to the Maintenance section of

this instruction manual to learn about the

proper cleaning procedure.

3 Once you have selected the Aroma360

scenting oil of your choice, carefully screw

the bottle counterclockwise into the

diffuser.

Important!

Make sure the bottle is screwed in tight and

parallel to the top half of the Aroma360

4 Once you have screwed on the Aroma360

oil, close the unit tightly by sliding the

upper half back into place and turning

clockwise.

5 Connect the power adapter into the

diffuser's power port and plug it into a 110V

power outlet. Position the power cord to

prevent it from being a tripping hazard.

DIFFUSER LED COLOR KEY

Blue LED Light - Indicates the device is powered on

Green LED Light - Indicates the scent is being diffused

Red LED Light - Flashes when any button on the

remote control is being pressed

REMOTE CONTROL FUNCTIONS

On and Off - Powers the device On and Off

OFF

Density + (plus) - Increases aroma's density by 10%.

Density

Press 10 times for maximum density

Density - (minus) - Decreases aroma's density by

10%. Press 10 times for minimum density

Pressing "Aroma" will cause the unit to work

AROMA

continuously. Adjust the settings according to the

density desired.

The blue buttons allow you to control the scent

20%

concentration by adjusting the scenting interval.

The options are: 20%, 35%, 50%, 65%, 80%, 95%

20% - Diffuser will diffuse scent for 40s and pause for 160s

50% - Diffuser will diffuse scent for 100s and pause for 100s

95% - Diffuser will diffuse scent for 180s and pause for 10s

Allows the diffuser to run continuously for a specified

amount of hours.

1h = 1 hour, 4h = 4 hours, 8h = 8 hours

RESETTING THE REMOTE CONTROL

Please follow these steps to reset the remote control to

its factory settings:

Unplug the diffuser from the power outlet.

Hold down the blue button on the remote labeled

"35%" for 5 seconds while plugging the diffuser back

into the wall outlet. A red light will flash on the diffuser.

Avoid pressing any buttons on the remote for 10

seconds as it takes time for the receiver within the

device to reset itself.