Acoustic B300C 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Acoustic B300C에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acoustic B300C 12 페이지.

BASS GUITAR AMPS

B600C BACK PANEL

1. AC Power Connection and Fuse: Connect included IEC power cable here. Fuse cap contains fuse for circuit protection

2. Speaker Outputs: 1/4" speaker jack and locking-barrel type jack for attaching external speakers (minimum 4 Ohm total load)

3. Link In: Accepts Input from another Acoustic™ bass combo or head's 'Link Out' output. This allows the user to link 2 combos or

heads together for more power and allows the sound to be controlled from one master amplifier

4. Link Out: Sends Output to another Acoustic™ bass combo or head with a 'Link In' input. This allows the user to link 2 combos or

heads together for more power and allows the sound to be controlled from one master amplifier

5. Effects Return: 1/4" two-conductor jack returns signal from external effects or signal processing devices

6. Effects Send: 1/4" two-conductor jack sends signal to external effects or signal processing devices

7. Ground Lift Switch: Lifts the ground from the XLR direct output. Useful for eliminating hum when the direct out is used

8. Direct Output: XLR direct balanced output connector jack for connection to an external PA, sound board or recording console

9. Direct Output Volume: Adjusts the level of the direct output signal

10. Pre/Post EQ Switch: Switches the direct balanced output between pre and post EQ operation. In 'pre' setting, the instrument

signal will be sent to the balanced output prior to any preamp EQ adjustments. In 'post' setting any EQ applied in the preamp

stage will be present in the signal sent to the balanced output.

11. Footswitch: 1/4" Tip/Ring/Sleeve jack for attaching optional 2 button latching footswitch. Controls Overdrive on/off and Effects

Loop on/off (Note: Engage overdrive switch after connecting footswitch, then use attached footswitch to turn off/on overdrive)

12. Tuner Send: This provides an additional send for easy routing of the instrument signal to a tuner. Attach electronic instrument tuner

via 1/4" two-conductor instrument cable

www.acousticamplification.com

9 10