Dish TV A2 빠른 시작 매뉴얼 - 페이지 15

{카테고리_이름} Dish TV A2에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dish TV A2 20 페이지. Freeview recorder
Dish TV A2에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (16 페이지)

Troubleshooting Tips

No Power Indicator on the Front Panel

Possible Cause: Unplugged/Switched OFF.

Solution 1: Check the Power Supply is plugged into both the Dish TV A2 and Wall

Socket correctly.

Solution 2: Ensure the Wall Socket is switched ON and there is power available.

No Channels

Solution 1: If the Satellite or UHF Aerial cable is NOT connected correctly, such as the

cable from your UHF Aerial is connected to the SATELLITE IN. The Dish TV A2 will be

unable to scan. Ensure the UHF Aerial/Satellite cable is connected correctly.

Solution 2: Perform a re-scan of the Channels.

1. Ensure the UHF Aerial/Satellite cable is connected.

2. Press the MENU

button to access the Home Hub.

3. Follow the steps according to the Home Hub Menu.

• Select Menu → Settings → Advanced Settings → Select Signal Type → YES.

Dish TV A2 is not responding to the Remote

Possible Cause: There are a number of reasons why your Remote may not be working.

This includes physical damage, battery issues, or pairing issues with the Remote.

Solution 1: Batteries that are depleted or incorrectly inserted are the most common

reason for a Remote to stop working, or work intermittently. We recommend replacing

the batteries as a first step, checking that the + and - ends of the batteries correspond

with the + and - markings in the battery compartment of the Remote.

Solution 2: Try re-pair the Bluetooth Remote.

1. On the left-hand side of the Recorder, find the small "circle" hole.

2. Press the button inside the small "circle" hole, for 3-5 seconds.

3. The Recorder will enter Pairing Mode, and will begin "Searching for Accessories".

4. Follow the on-screen instructions to pair the Bluetooth Remote.

4. See Page 04 on Connecting the Bluetooth Remote.

Live Pause / Recording has stopped working.

Solution 1: Try turn off the Dish TV A2 completely for 30 seconds, then turn it back on.

Solution 2: Contact Dish TV for assistance, to check the status of the Hard Drive.

Solution 3: See Page 16 to Factory Data Reset the Dish TV A2, during setup it will try

reconfigure the Hard Drive.

TIP: Before contacting Dish TV for any issues, go to Menu → Settings → Help, or try

turning off the Dish TV A2 for 30 seconds. If the issue persists, contact Dish TV.