3D R DIY QUAD 조립 설명서 - 페이지 12

{카테고리_이름} 3D R DIY QUAD에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D R DIY QUAD 12 페이지.

Remove plastic rings from propeller package, select the one with the smaller internal

diameter, and insert it into the back of the propeller hub.

Add propeller to motor collet with writing facing up in

relation to the sky. Add the washer and prop nut above

the propeller; tightly fasten prop nut to threaded collet.

Safety Check! Ensure writing on props faces up.

S E CU R E W IR IN G

Before flying, use zip ties to secure ESCs to the frame. Ensure that

all wires are secured so they will not become entangled in spinning

propellers, are not too tight around corners (no hard 90-180 degree

bends), and do not pull on the APM

or other components. Always

complete the pre-flight checklist

before takeoff

(copter.ardupilot.com/wiki/checklist).

Visit

hardware and software configuration, using autonomous flight

modes, tuning, designing missions with waypoints and events,

troubleshooting, and more. Happy flying!

SU P PO RT

For more information about software, firmware, and flight behaviors, visit

the APM Copter community documentation project at copter.ardupilot.com.

For customer support, contact us at

support line at

For more assembly instructions and information about building and

configuring your copter, visit 3drobotics.com/learn.

copter.ardupilot.com

+1 (858) 225-1414

Collet

to learn about multicopter safety,

Monday through Friday, 8 am to 5 pm.

Prop nut

Washer

Propeller

Motor

ESCs and wiring secured with zip ties

or call our