Acoustic B600H 사용자 설명서 - 페이지 8

{카테고리_이름} Acoustic B600H에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acoustic B600H 16 페이지. 200 watt combo, 200 watt head, 410 cabinet, 115 cabinet, 600 watt head, 810 cabinet

페이지 인쇄

B600H

1. 1/4" Passive input – use for bass guitars with passive pickups.

2. 1/4" Active input – use for bass guitars with active pickups. This input is -10dB from the passive input.

3. Mute switch – push button in to activate mute circuit. The red light will come on.

4. Gain control – set so clip indicator is not lit, otherwise distortion may occur.

5. Volume level control – set to your desired volume level. If distortion occurs, reduce volume level.

6. Active -10 dB notch at frequencies from 50Hz to 1kHz - approximately 250Hz with the frequency knob at

12 o'clock. Notch on/off switch is foot-switchable.

7. Active low frequency control – set to boost (+12 dB) or cut (-12 dB) frequencies centered around 63 Hz.

8. Active low-mid frequency control – set to boost (+12 dB) or cut (-12 dB) frequencies centered around 150 Hz.

9. Active low-mid control – set to boost (+12 dB) or cut (-12 dB) frequencies centered around 350 Hz.

10. Active high-mid control – set to boost (+12 dB) or cut (-12 dB) frequencies centered around 800 Hz.

11. Active high frequency control – set to boost (+12 dB) or cut (-12 dB) frequencies centered around 2 kHz.

12. Active high frequency control – set to boost (+12 dB) or cut (-12 dB) frequencies set centered around 5 kHz.

13. On/Off light - when this jewel light is lit, your amp is on and ready to be played.

14. Power switch - turns amp on or off.

rEAr pANEl lAyOuT

B200H

1. Speaker Out: Two-conductor, 1/4" Speaker Output Jacks, 4 Ohms minimum

load, parallel.

2. Effects Loop Send & Return: Unbalanced, 1/4" Line Output Jack. These jacks

will allow a signal to be sent to an external effects device or equalizer, then

patched back in before the power amp section.

3. Direct Out with Volume Control: This sends a line-level signal to a PA system

or recording device. Use the Direct Out Volume knob to prevent clipping.

4. Ground Lift Switch: Lifts ground on pin 1 on XLR.

w w w . a c o u s t i c a m p l i f i c a t i o n . c o m