Disney P500BE 사용자 설명서 - 페이지 6

{카테고리_이름} Disney P500BE에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Disney P500BE 6 페이지. Jewelry box cd boombox

페이지 인쇄
Caring for Discs
• Treat the disc carefully. Handle the disc only by its edges. Never
allow your fingers to come in contact with the shiny, unprinted
side of the disc.
• Do not attach adhesive tape, stickers, etc. to the disc label.
• Clean the disc periodically with a soft, lint-free, dry cloth. Never
use detergents or abrasive cleaners to clean the disc. If
necessary, use a CD cleaning kit.
• If a disc skips or gets stuck on a section of the disc, it is
probably dirty or damaged (scratched).
• When cleaning the disc, wipe in straight lines from the center of
the disc to the outer edge of the disc. Never wipe in circular motions.
• Discs should be stored in their cases after each use to avoid damage.
• Do not expose discs to direct sunlight, high humidity, high temperatures or dust, etc. Prolonged
exposure or extreme temperatures can warp the disc.
• Do not stick or write anything on either side of the disc. Sharp writing instruments, or the ink, may
damage the surface.
Cleaning the Unit
• To prevent fire or shock hazard, disconnect your unit from the AC power source when cleaning.
• The finish on your unit may be cleaned with a dust cloth and cared for as other furniture. Use
caution when cleaning and wiping the plastic parts.
• Mild soap and a damp cloth may be used on the front panel.
Check the following guide for the possible cause of a problem before contacting service.
Symptom
Player will not turn on.
Disc will not play
Erratic CD playback
No sound from speakers
Power source
Power consumption
Frequency response
Power Output
Speaker
External dimensions
* Design and specification are subject to change without notice.

CARE AND MAINTENANCE

TROUBLESHOOTING GUIDE

Cause
• AC line cord not connected.
• CD Compartment not closed.
• Disc inserted incorrectly.
• Dirty or defective disc.
• Moisture condensation on disc.
• Dirty or defective disc.
• Player is subject to vibrations or
physical shock.
• Laser lens is dirty.
• ON/OFF button not selected to ON
• Voulme +/- button not controlled
• CD/AUX button not selected to
ON.

SPECIFICATIONS

AC 220V-240V ~ 60Hz
12W
100 – 18,000 Hz
1W + 1W
2.5" 8 ohms x 2
280 (L) x 200 (W) x 215 (H) mm
• Check AC line cord connecting.
• Close CD Compartment.
• Reinsert disc correctly.
• Try another disc.
• Wipe disc with soft cloth.
• Clean or replace disc.
• Change the installation location.
• Clean using a quality laser lens cleaner.
• Press the ON/OFF button to ON (
• Press the VOLUME + button to
increase sound level.
• Press the CD/AUX button to CD mode
(
GB - 5
Correction
), or AUX mode (
)
).