ARP Pro Solois 설치 매뉴얼 - 페이지 5

{카테고리_이름} ARP Pro Solois에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ARP Pro Solois 7 페이지.

Figure 3 - Sliders Assembly Tack Soldered (Each slider soldered in place by only one pin)

dicular to the pcb and the slider PCB is parallel with the ARP PCB.

Notice that the sliders can easily be moved into alignment by gently

moiving them or heating up the tack solder joint. Don't hold the sol-

dering iron tip to the tack solder joint for more than 2-4 seconds. Too

much heat can cause the slider adapter PCB pins to become unsol-

dered.

You can now test fit the PCB to the chassis. When you have fit the

PCB back into the chassis of the synth, screw the PCB into place. Ad-

just any sliders that arent straight, then solder each sliders remaining

pins int the PCB. When the PCBs are screwed into the chassis, you

can gently hold the slider into the desired position and solder the

remaining legs.

5) When the assemblies have been wired to the PCBs, you can con-

nect the LED assembly to the synth's +5V power supply. This allows