Abbott NT000iX 빠른 시작 매뉴얼 - 페이지 7
{카테고리_이름} Abbott NT000iX에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Abbott NT000iX 16 페이지. Rf generator
페이지 인쇄
STIMULATION AND TREATMENT
IF YOU SELECTED SENSORY OR MOTOR ON THE CHOOSE TREATMENT SCREEN:
1. Turn the Stim Output knob located on the left side of
the generator clockwise to increase voltage.
2. Tap Log to record the value in the procedure record.
The bar value will remain on the screen.
IF YOU SELECTED LESION ON THE CHOOSE TREATMENT SCREEN:
1. Tap Lesion, Pulsed or Dosed at the top of the screen to choose your treatment mode.
2. For Lesion and Pulsed modes, tap Manual or Auto to
start the procedure.
• For a manual procedure, use the RF Output knob
located on the right side of the generator.
*NOTE:
Pressing the red "Emergency Stop" button on the generator's front panel will require
a reboot of the machine.
3. Turn the Stim Output knob back to its starting position
and repeat for any additional sites.
3. For Dosed mode, tap Auto to start the procedure.
4. To stop before the procedure is complete, tap Stop on
the screen* at any time.
This document is a guide. For complete details, always refer to the NT2000iX
RF Generator Operator's Manual.
7
™