Aerial AD 110 사용 설명서 - 페이지 3

{카테고리_이름} Aerial AD 110에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aerial AD 110 13 페이지. Aerial ad 110 dehumidifier instruction manual

1. General advice

You have bought an air dryer made by AERIAL thus deciding for a proven quality

product "Made in Germany". If nevertheless complications should occur, you will

find some advice hereinafter how to eliminate such difficulties as quickly as possible.

ATTENTION PLEASE!

Immediately after receipt, you should check your air dryer for transport damage! In

the case of damage, you should inform the forwarding agent, parcel service, post

office etc. accordingly upon receipt, and make a note of it on the forwarding

documents!

If a transport damage should be stated after unpacking the equipment, please

contact immediately your respective seller or specialized trader

Before putting your air dryer into operation for the very first time, these instructions

for operation should be studied very thoroughly. Thus, you can make sure that this

appliance will operate perfectly for a long period of time saving yourselves

unnecessary repairs and expenses.

In the case of technical unclarity or faults disconnect your appliance and ensure that

it is not connected again by taking the mains plug out of the socket.

Please, keep the device wrapping in order to be able to send the device safe

for guarantee repair. In order to save place you open simply the adhesive tape

with a knife and you fold the carton.

The AD-air dryer is constructed exclusively for air drying in closed rooms. That

dehumidifier can prevent the formation of sweating water, eliminate too high air

humidity and hold a specific air humidity unchangeable. The time which the dryer

requires in order to achieve a specific humidity depends essentially on the

environmental conditions. The attainable humidity value is equally dependent on the

environmental conditions.

The AD-dehumidifier works according to the condensation principle with heat

recovery. The fan (partial positions see detail drawing) suck the moist air through a

cool register (evaporator). The air becomes so far chilled under the point of

condensation here, that the steam of air condense as water and flows through the

connected hose into a sump. The chilled and dried air is warmed up at the

condenser again. Through the heat pump effect, the outlet air is some degrees

warmer than the sucked room air. Vigour profit can conducted up to 3-fold of the

electrical power consumption. The absolute moisture of air is lowered continuously

by the continuous circulation of the room air through the device. The surplus

moisture is removed takingly and efficiently.

page 3 of 13