3D Systems Cubify CUBEX Trio 교체 매뉴얼 - 페이지 8

{카테고리_이름} 3D Systems Cubify CUBEX Trio에 대한 교체 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems Cubify CUBEX Trio 13 페이지. Print jet replacement manual

2. Place the Print Jet onto the Print Jet carriage plate as pictured, note the

locating standoff and corresponding hole present on the Print Jet

3. Ensure that the wires from the Print tip are orientated to travel straight up to

the Sensor board

4. Replace the M3 x 20 bolt into the hole as pictured and fasten. This must be

tight.