displayit GRAFFITY:PLUS 조립 지침 매뉴얼 - 페이지 5
{카테고리_이름} displayit GRAFFITY:PLUS에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. displayit GRAFFITY:PLUS 9 페이지. 10x10 inline display kit a
페이지 인쇄Caution! Installing silicone-edged graphics is techniqe sensitive;
Practice will shorten installation time.
How to Install SEG Graphics:
Turn and tuck the side of the graphic with the silicone welt into the SEG groove.
The stitched ege goes into the groove first.
Press While
Sliding Hand
Pulling on the silicone welt during installation stretches the silicone and
creates a bulge in the silicone welt that is difficult to correct smoothly.
A
B
A. Tuck the graphic into left/upper endcap SEG
channel and partially down the vertical channel bar.
B. Holding the graphic off of the ground, tuck the
center of the graphic on the front of the frame.
C. Tuck the graphic into the right endcap.
displayit.com
Graphic Installation Instructions
Stitched edge
goes in first
SEG
groove
Start in
the corner
INCORRECT
Pull
Silicone
Bulge
Installing Fabric Graphics with Endcaps
C
E
D. Complete installation of the top
edge of the graphic.
E. Tuck the bottom/front corners
and the middle of the bottom/front.
800.207.0311
Tuck
A series of tucks reduces excess silicone.
D
D
E
E
After-Hours Emergency: Call or Text 678.723.5343
10x10 Inline Display Kit A
Assembly Instructions
Handle graphics with care with clean hands in a
clean environment. Clean cloth or latex gloves
are recommended.
CORRECT
Tuck
Tuck
G
G
F
F
F. Complete installation on the
bottom/front.
G. Complete installation of both
endcaps.
Updated 3/15/2019
G
G
5