Arrakis Systems Simple-IP-8A 제품 설명서 - 페이지 8
{카테고리_이름} Arrakis Systems Simple-IP-8A에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Arrakis Systems Simple-IP-8A 17 페이지. Aoip router
페이지 인쇄Ethernet Cabling
While Simple-IP and Dante will operate on 100Mbit networks, a Gigabit network is recommended. Cable
types should be either: (1) CAT5e, or (2) CAT6.
Both shielded and unshielded cables are suitable but shielded cables may be more appropriate depending
on your RF environment.
Standard maximum cable length between devices is 100 meters.
Wireless (WiFi) networking is not recommended.
Wide Area Networks are not supported by DANTE at this time.
Network Switches
Networked audio with Simple-IP and DANTE is not difficult at all. A DANTE network requires at least one
ethernet switch. Each DANTE device is connected to the switch via an ethernet cable. In larger installations
multiple switches will be used. While off-the-shelf switches are used with DANTE networks, the choice of
switch can be important. Unmanaged ethernet switches will function well in some network configurations,
However, DANTE recommends the use of 'managed' ethernet switches for maximum reliability.
Some example switches are:
Cisco SG200 series
Cisco SG300 series
Netgear GS700T series
MANAGED SWITCH DSCP VALUES (refer to the switch manual for setup instructions)
DSCP Value
CS7
EF
CS1
Best Effort
Ar r a k i s S ys t e m s i n c .
Ethernet Hardware
Priority
High
Medium
Low
None
L o ve l a n d , C O
Usage
Time Critical PTP events
Audio, PTP
reserved
Other traffic
9 7 0 - 4 6 1 - 0 7 3 0
w w w . a r r a k i s - s ys t e m s . c o m