displayit flare 조립 지침 매뉴얼 - 페이지 2
{카테고리_이름} displayit flare에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. displayit flare 6 페이지. Accessory kiosk with three shelves
displayit flare에 대해서도 마찬가지입니다: 조립 지침 (2 페이지)
페이지 인쇄1. Upack the frame. Save all foam pieces for repacking later. Lay out the frame pieces as seen in Diagram 1.
Frame perimeter pieces are labeled with stickers matching Diagram 1 to make this step easier.
Take note where the velcro strips for the power supplies are located on Diagram 1.
Assemble the frame on its back.
46" SIDE
CORNER
46" SIDE
CORNER
Wire Pass-through
2. Assemble frame top,
bottom, and sides using
four flat connecting plates.
Hand tighten wing nuts to
secure.
displayit.com
46" TOP
CORNER
Diagram 1
Velcro for Power Supplies
Foot Holes
46" BOTTOM
CORNER
Vertical
Vertical
3. Assemble perimeter of
frame with four corner
connecting plates.
CAUTION:
METAL EDGES
MAY BE SHARP
800.207.0311
After-Hours Emergency: Call or Text 678.723.5343
Assembly Instructions Page 2
46" TOP
CORNER
Support Pole
Location
Foot Holes
46" BOTTOM
CORNER
Horizontal
Horizontal
Note: It's best to build the frame laying on its back.
8' (92" x 92") Flare
46" SIDE
CORNER
46" SIDE
CORNER
Flare v2.0 Updated 11/22/2016