Aerial AD 630F 사용 설명서 - 페이지 5

{카테고리_이름} Aerial AD 630F에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aerial AD 630F 18 페이지. Condensation dryer

Instruction manual condensation dryer AD 530 / AD 630 / AD 630F

5 Electrical connection

Before connecting the air dryer, the following items must be checked:

Does the mains voltage coincide with the voltage of the appliance?

Adequate fusing of socket and supply system?

Has the required residual-current-operated circuitbreaker (r.c.c.b) been installed in case of

swimming baths?

If a cable drum is used: has it been unwound completely?

Is the appliance connector suitable for the building socket?

Is the socket provided with a perfect grounding?

Attention!

Before putting the air dryer into operation, the technical data of the appliance should be

compared to the conditions prevailing in the room of installation!

Attention!

Before putting the air dryer into operation, the instruction manual should be studied carefully.

Thus, damages by a false or inappropriate operation as well as by inadequate environmental

conditions can be avoided.

For using the air dryer, please proceed as follows:

After having been transported, the air dryer should rest for abt. 15 min. During this period

of time, the oil distributed inside the refrigerating system and frothed during transport will

return into the compressor. We recommend this procedure since it extends the service life

of the compressor.

Put the plug into the socket.

Check whether the bucket is inside the equipment resp. whether the drain hose has been

fastened and laid appropriately.

Switch on the appliance by actuating the ON-OFF-switch. The latter is located at the side

wall on the right and must be illuminated after actuation.

Set the required humidity value at the hygrostat (please refer in this respect to 'Hygrostat

Control').

If the existing humidity is higher than the set value, the air dryer will start to operate.

If the existing humidity is lower than the set value, the air dryer will not start to operate.

from serie July 2003

page 4

AERIAL GmbH