3D Systems ProJet SLA 7000 원본 지침 - 페이지 3

{카테고리_이름} 3D Systems ProJet SLA 7000에 대한 원본 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems ProJet SLA 7000 4 페이지. Long term shutdown procedure

4. Navigate to

C:/Program Files/3D Systems/ProJet 6000/current_version/Data/

Copy the default geo file and paste it into the PJ6KBackup folder.

Copy the EncoderCalibration dat file and paste it into the PJ6KBackup folder

Copy the PowerCal folder and paste it into the PJ6KBackup folder.

5. Navigate to

C:/Program Files/3D Systems/ProJet 6000/license/

If there is no License dat file present, disregard this step.

If there is a License dat file present, copy and paste it into the PJ6KBackup folder.

6. Copy and paste the entire PJ6KBackup folder onto a flash drive or alternate storage device. Keep this folder in a secure

location in the event the files inside are needed.

POWERING OFF THE SYSTEM

Below are two options for powering off the system. Choose an option that best suits your situation.

1. While still in Windows

1. Click on the Start button.

2. Click on Shutdown and wait for Windows to complete the shutdown process.

3. Go to the rear of the machine and toggle the power switch to the right to turn off the power to the system.

4. If you wish you can disconnect the electrical power cable from the machine or the wall.

2. While In The User Interface

1. At the bottom of the touch screen, tap the Advanced button.

2. Tap on the Printer button

3. Tap on the Shutdown Printer button.

4. Confirm that you want to Shutdown the Printer.

5. Wait for the system to complete shutdown.

6. Go to the rear of the machine and toggle the power switch to the right to turn off the power to the system.

7. If you wish you can disconnect the electrical power cable from the machine or the wall.

3D SYSTEMS, INC.

P/N 40-D119 REV_A