Distech Controls Allure ECB-103 설치 매뉴얼 - 페이지 6

{카테고리_이름} Distech Controls Allure ECB-103에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Distech Controls Allure ECB-103 16 페이지.
Distech Controls Allure ECB-103에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지)

페이지 인쇄

Subnetwork Bus Topology and EOL Terminations

Only a daisy chain topology is acceptable for the room device subnetwork bus. T connections are not allowed.

Some controller models support the connection of other devices to the Subnet Port as part of the Smart Room Control solution (see the controller's

datasheet for more information).

For non ECB-600 or ECL-600 Series controllers, only the EOL terminations of the last subnetwork bus device are set to ON. All other subnetwork bus

devices must have their EOL terminations set to OFF. The controller must be the first device on the Cat 5e Cable Subnetwork bus as its internal EOL ter-

mination is permanently enabled.

See Table 1 for the number of Allure EC-Smart-Vue sensors that a given controller model can support.

Controller Series:

· ECB-VAV-O

· ECB-VAVS

· ECB-VVTS

· ECB-VAV-N

· ECB-103

· ECB-203 Series

· ECB-300 Series

· ECB-400 Series

Figure 7:

Setting the EOL Terminations on the Allure EC-Smart-Vue Sensor for non ECB-600 or ECL-600 series, non-Smart Room Con-

trol controllers

Controller Series:

· ECB-VAV

· ECL-VAV

· ECLYPSE (ECY-VAV, ECY-S1000)

· ECB-PTU Series

· ECL-PTU Series

Figure 8:

Setting the EOL Terminations on the Allure EC-Smart-Vue Sensor for Smart Room Control-compatible controllers

When one or more Allure EC-Smart-Vue sensors are installed with an ECB-600 or ECL-600 (without an ECx-4xx IO Extension Module), only the EOL

terminations on the ECB-600 / ECL-600 and the last Allure EC-Smart-Vue sensor are set to ON. All other Allure EC-Smart-Vue sensors must have their

EOL terminations set to OFF.

6 / 16

Typical Room Devices

Cat 5e Cable Subnetwork Bus

· ECL-VAV-O

· ECL-VAVS

· ECL-VVTS

· ECL-VAV-N

· ECL-103

· ECL-203 Series

· ECL-300 Series

· ECL-400 Series

Cat 5e Cable Subnetwork Bus

Back of Allure

EC-Smart-Vue

EOL set to ON

at the last

sensor at the

end of the Bus