Aerialix ARLX-OM2400 빌딩 매뉴얼 - 페이지 10

{카테고리_이름} Aerialix ARLX-OM2400에 대한 빌딩 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aerialix ARLX-OM2400 12 페이지. Collinear antenna kit

802.11 2.4Ghz Low-Power 5dBi Vertical Collinear Antenna

Figure 14. Leave enough room to apply epoxy into the decoupler end of the radome.

Set aside and prepare to ready the epoxy. Ready the mixing container, the stiring/applicator utensil, and a dry cloth or paper

towel.

Be sure to read the instructions and follow the safety procedures outlined on the epoxy manufacturers label. Then, dispense

approximately 10ml(.338 oz), or 1/4 of the container, of the 50/50 epoxy into the mixing container and prepare in accordance

with manufacturers directions. If you chose fast acting epoxy, you probably have only 5 minutes or so before the epoxy begins

to SUDDENLY harden.

Starting with the decoupler end of the radome, apply epoxy liberally into the opening of the radome as shown in Figure 15.

Take care to not let any epoxy dribble down the side of the radome. If this should occur, quickly wipe away with a dry cloth or

paper towel.

Figure 15. Applying epoxy into decoupler end of radome.

Insert the antenna the rest of the way, stopping when the base of the decoupler is flush with the end of the radome. Apply more