3d-printz Naughty 2000 사용 설명서 - 페이지 4

{카테고리_이름} 3d-printz Naughty 2000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3d-printz Naughty 2000 9 페이지.

Build

Wing

The middle of the wing is glued first – to do this, join the parts WingCR, WingCL and

Centerjoiner together with superglue. The 10mm and the 8mm carbon tube serve as

a guide rail (caution – do not glue the carbon tubes!).

Then the left and right wing and the flaps (aileron, flaps) can be assembled. The

10mm carbon tube and the 8mm carbon tube serves as a guide rail again. The flaps

can be reinforced with a carbon rod (2mm) if required, but this is optional. Never

glue the center of the wing to the rest of the wing if it should remain divisible!