3Dazer DZ-ID1601-P1 사용자 설명서 - 페이지 6

{카테고리_이름} 3Dazer DZ-ID1601-P1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Dazer DZ-ID1601-P1 12 페이지.

Install The Metal Plate Mount

3Dazer provides 2 positions options for attached mode:

• Upper edge

• Bottom edge

Set the position in the app settings and install the metal plate

mount included in the package. Follow the instructions below

to install the metal mount properly. Illustrations are on the

following page.

1. Lift the installation kit and device out of the box, turn

over the device with the backside facing up.

2. Take out one of the metal plate mounts and place it in

the magnetic holder (the slot) on the back of the device

with the adhesive tape side up.

3. Stand the installation kit on a flat surface such as table,

desk, or counter top with the appropriate positioning

arrow indicated and then peel off the protective paper

on the plate mount.

4. Stand your phone (with or without the case) on the same

surface and move the kit towards the phone slowly. Make

sure the phone is in the middle of the kit before putting

them together and squeeze for a few seconds before

pulling the kit away.

5. Now the metal plate mount is installed on your phone.

Note: When setting up your account, you will be prompted to indicate

which position you chose. Or change in settings.