3dBatix Foame IIx 3D 매뉴얼 - 페이지 7

{카테고리_이름} 3dBatix Foame IIx 3D에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3dBatix Foame IIx 3D 8 페이지. Biplane

Elevator and rudder carbon fiber pushrods. These rods have Z-bends at one end, and are sized for the

servo to surface distance. Set the servo arm to a 90 deg position, and insert the Z-bend into the control

horn on each surface, then run the pushrod through the servo arm holder, and tighten the set screw with

the small hex wrench.

Aileron pushrods. These rods are short and have Z-bends at one end. Set the aileron servo arms to 90

deg positions, and attach the ailerons pushrods the same as the elevator and rudder pushrods, tightening

the set screws through the small holes in the bottom wings.