CAME 8K01MB-0572 STYLO KIT 빠른 설정 매뉴얼 - 페이지 8
{카테고리_이름} CAME 8K01MB-0572 STYLO KIT에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAME 8K01MB-0572 STYLO KIT 12 페이지. Complete kit for a single swing gate weighing up to 100kg per leaf / max. width 1.8m
페이지 인쇄ZL92Z:
Important!
1
2
Ensure the wiring is complete (refer to the wiring diagram) & any required physical stops are set before
commencing with programming
1.
Power on the control panel
2.
Press and hold the
3.
Disable total stop –
4.
Disable safety inputs –
5.
Disable safety test –
6.
Set the number of motors –
7.
Set the motor type –
CAUTION, Ensure the gate movement area is clear of all obstructions
8.
Check the motor direction
Press and hold
The gate should open, if not reverse the motor cables for motor 2 (Connections M2, N2)
Leave the gate in the halfway position.
9.
Setup the Encoder
10. The Gate will now perform a close and open cycle.
12. Exit the programming using the
13. Check the gate operation by pulsing across connections 2 & 7, the gate will close
Changing automatic closing time, adjusting encoder settings if required
Safety inputs should now be configured and the gate force tested as required.
Please refer to the full manual to complete the commissioning.
Should the gates not operate as suggested above,
call CAME helpline
QUICK START GUIDE
1
• Exit the menu
• Delete the changes
• Go back to the previous screen
2
• Navigate the menu
• Increase or decrease values
3
• Access menus
3
• Confirm a choice
button for 2 seconds to access programming. (
F 1
O
–
F 2
F 3
&
–
F 5
O
–
F 4 6
–
A 1
1
–
A 2
1
–
A 3
1
–
button.
Please refer to the main manual for:
0115 921 0430
The installation must be carried out
by skilled and qualified personnel
button - used to perform the following operations:
buttons - used to perform the following operations:
button - used to perform the following operations
O
1
for technical support.
F 1
appears on the display).
Tick