Acoustic Image Ten2 EX 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Acoustic Image Ten2 EX에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acoustic Image Ten2 EX 8 페이지. S4plus
Acoustic Image Ten2 EX에 대해서도 마찬가지입니다: 소유자 매뉴얼 (10 페이지), 소유자 매뉴얼 (12 페이지)

페이지 인쇄

1. Controls

CH 2

RETURN

RTN

LEVEL

BYP

CH 2

SWITCH

CH 1

SWITCH

BYP

CH 1

RETURN

RTN

LEVEL

HEADPHONE

OUTPUT

H/P

AMP

Stereo Operation

The two-channel preamp of the

Ten2

can be operated in stereo mode. When it

is in the "on" position, the switch labeled "Ch 2" connects the channel to the

internal power amp and speaker. When it is in the "off" position, it is

disconnected

from the internal amp but is accessible from the channel 2 send

output. By connecting the send output to a satellite power amplifier, and putting

the switch in the off position, the preamp operates in stereo mode. Note that

channel 2 remains in the direct out signal even when the switch is in the off

position. This is done since stereo operation is typically a "stage" mode but not

a "house" mode (house systems are typically not stereo). The Ch 2 switch has

a red button to remind you that is is an important switch.

will not be heard through the speaker system unless the Ch 2 switch is in

the depressed or on position. If you are not hearing channel 2 in the

output, check to be sure that the switch is on.

Effects

Our high-quality effects unit offers 6 program selections: 3 reverb programs

(Hall, Room and Plate), a delay, an ambient chorus and a flanger. There are

switches to select which of the two channels are processed by the effects unit.

Either channel can be connected to the effects unit. If both switches are

engaged, the selected program appears in both channels. A level control

affects the level of the effects signal that is mixed with the "dry" signal to control

the overall effect of the selected program. You should experiment with both the

program selection and the level control to find the sound that you prefer. When

effects are not used, the switches for both channels should be off and the level

control should be turned fully counterclockwise. Note that the flange effect is

noisy, it is normal the hear the modulation of the flanger when no signal is

present.

Headphone Output

There is a headphone output on the rear panel of theTen2. You can plug a

standard 1/4 inch stereo plug into this output to connect a headphone for

private listening. If your headphone has a 1/8th inch plug, you can buy an

adapter to allow you to use the 1/4 inch output jack.

When you plug into the jack, the amp is muted. Sound will only be heard

through the headphones. The headphone is connected to the output of the

preamp so all of the controls on the preamp, including effects, will affect the

signal heard through the headphone. When the headphone plug is removed

from the jack, the amp will come back on.

There is about a 5 second delay

between removal of the plug and the amp coming back on, so expect a

pause before you will hear anything from the amp after the headphone is

removed.

Anytime anything is plugged into the headphone output jack, the

amp will be muted so make sure that nothing is plugged into the jack when you

want to use the amp normally.

Docking System

The amp head component of the Ten2 can be removed and used as a stand-

alone amplifier. To remove the head unit, first disconnect the short speaker

Note that channel 2