CAME BX241 설치 매뉴얼 - 페이지 6
{카테고리_이름} CAME BX241에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAME BX241 17 페이지. Automation systems for sliding gates
CAME BX241에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지), 매뉴얼 (20 페이지)
페이지 인쇄
5.5 Unit installation
During the initial phase of installation, the feet should protrude by 5-10 mm. in order to allow for alignment, anchorage of the
rack and further adjustments.
Perfect alignment with the guide rail is made possible by the (paten-ted) built-in regulation system, which consists of:
- slots for horizontal adjustment;
- threaded steel feet for vertical adjustment and levelling;
- plates and bolts for anchorage to the base.
Cable entrances
5.6 Attaching the rack/limit
Attach the rack to the gate
as described below:
- Release the gearmotor (parag. 5.8);
- position the rack on the pinion of the gearmotor and slide the gate manually in order to attach the rack along its entire length;
- when the rack is attached to the gate, adjust the feet using a screwdriver until the play between the pinion and the rack is
correct (1-2 mm.).
N.B.: This position ensures that the weight of the gate does not rest on the gearmotor.
- If the rack is already attached, proceed directly to the adju-stment of the rack/pinion coupling.
- when the necessary adjustment have been completed, fasten the unit in position by tightening the two anchor bolts.
6
Horizontal adjustment
and unit anchorage
Rack-to-pinion coupling
with 1÷2 mm clearance
Vertical adjustment
and unit leveling