CAME BY-3500T 빠른 설정 매뉴얼 - 페이지 4
{카테고리_이름} CAME BY-3500T에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAME BY-3500T 12 페이지. Complete kit for a sliding gate weighing up to 3500kg / max. width 23m
CAME BY-3500T에 대해서도 마찬가지입니다: 매뉴얼 (17 페이지)
페이지 인쇄
BY-3500T:
9
INSIDE OF GATES
1 BY-3500T Motor
2 Limit switch fins
3 Reception Antenna
4 Flashing Light (optional)
CONTROL PANEL
•
The control panel is integral to the motor and is accessed by removing the outer cover.
•
The control panel is protected by a board-protection cover which will need to be removed for initial wiring.
Only a competent service provider should open the enclosure
and adjust the settings.
PHOTOCELLS
•
The photocells are used in pairs, one transmitter and one receiver.
•
They should be installed between 500-600mm from the ground, facing each other.
•
Power for the photocells is taken from the control panel 24v AC.
•
The maximum range of the photocell should always be observed.
When the photocell beam is broken, the control panel can be programmed on how to react.
Please see 'Safety' section for more information.
TYPICAL GATE SETUP
1
2
7
5
Selector Keypad (optional)
6
Photocells (on outside of gate posts)
7
2nd set of Photocells (optional)
8
Mechanical End Stop (not supplied)
6
11
9
10
11
12
OUTSIDE OF GATES
4
3
5
Photocell column (optional accessory)
Slide guides
Rack
Sensitive safety-edge