CAME C-BXE24 설치 매뉴얼 - 페이지 16

{카테고리_이름} CAME C-BXE24에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAME C-BXE24 20 페이지. Automation for industrial closures
CAME C-BXE24에 대해서도 마찬가지입니다: 매뉴얼 (16 페이지)

페이지 인쇄

5.9 Adjusting mechanical end-stops

Make sure the door is in a closed position

and the two crown wheels of the motor

units are both positioned to the left.

N.B.: the gearmotor is already adjusted

in a closed position, namely, the closing

end-stop micro-switch is activated.

Execute a complete opening run manually

or by using the button on the command

board; the two crowns will move to the

right.

Using a screwdriver, raise the end-stop

spring from the crown wheels; manually

move the white crown until it reaches the

opening microswitch and then lower the

spring onto the crowns.

Make a complete closing run and ensure

that the release lever is free from the

safety lever.

NB: the safety lever releases the

emergency release (CMS or C002) only

when the door is closed.

Warning! After making the adjustments

on sectional doors in a closed position,

there may be a gap between the lower

edge of the door and the ground

surface. To eliminate this gap, move the

micrometric lever one step up or down to

lower or raise the door by one centimetre.

Microswitch of end-stop in closing

White opening crown

Red closing crown

End-stop spring

Microswitch of end-stop in opening

Safety lever

Release lever

Micrometric lever