Acoustic Remedy ClimaCab 설정 및 사용 - 페이지 5

{카테고리_이름} Acoustic Remedy ClimaCab에 대한 설정 및 사용을 온라인으로 검색하거나 PDF를 다운로드하세요. Acoustic Remedy ClimaCab 10 페이지.

C L I M A C A B

1.) To begin, move the foam lined crate near the final use location. The crate is constructed of 3/4"

plywood and each piece is secured with screws. Locate the front panel and remove it using a drill

or screwdriver with appropriate Phillips head drill bit.

2.) Once the crate is open, remove the foam piece behind the front panel and set aside. Repeat

the process with the sides and back pieces of plywood and foam pieces to gain full access to the

ClimaCab. At this point the ClimaCab should be sitting on the base of the crate.

3.) The easiest method to remove the ClimaCab is to first remove the lower section doors.

Information on how to remove them is included here. Following removal of the lower section

doors, a good handhold is along the face frame of the lower section. At a minimum, use one

person at the left and right side. Carefully grab near the front corners and place the other hand on

the back of the ClimaCab.

4.) With knees bent, lift the ClimaCab slightly off the base and set on the floor adjacent to it.

5.) Once uncrated, please inspect the entire cabinet for any damages during shipping and contact

us ASAP upon discovery of any damage. We will work with you to solve any issue big or small, so

please don' t hesitate as time is of the essence in making insurance claims against the shipping

company.

6.) Open the bottom storage compartment doors to locate two boxes. Included in one box are the

accessories, including String Swing hangers (both top rail & slat wall), cork lined bout rails, neck

holders, any specialty hangers, the wood cover plate, Boveda Packet holders, the LED light

remote, handles, and other accessories which will require short installation during the set up

phase. In the other box is the Vigilant humidifier reservoir.

7.) For the Top Rail Display/Storage Option, the hangers will be attached to small angled wood

blocks. Carefully unpack the hangers and locate the small Allen wrench. The Allen wrench is

necessary to remove the small wood block that is threaded into the top of the ClimaCab ceiling

on the right hand side. Remove the block to expose the entry point of the hanger block. Insert the

blocks into the Top Rail and slide to the left.. The wood block will slide into the opening and

opposing angles will keep it secure. All hangers can be pivoted at the yoke with the small thumb

screw located on the back side of the yoke.

For the Neck/Bout Rest Display/Storage Option, remove the Neck Wedges from the box. On

the backside of the wedge, a single neodymium magnet is inserted flush with the wood surface.

This magnet attracts the wedge to the rail. Insert the Neck Wedge into the Neck Rail, mounted

approximately at the center point along the back of the ClimaCab. Remove the Bout Rails and

A C O U S T I C R E M E D Y

S E T

SET UP AND USE DIRECTIONS

U P

A N D

U S E