Acoustic Research AW-871 설치 및 운영 매뉴얼 - 페이지 8

{카테고리_이름} Acoustic Research AW-871에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acoustic Research AW-871 12 페이지. 900mhz wireless stereo speakers
Acoustic Research AW-871에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (15 페이지)

페이지 인쇄

V. Turning the Speakers Off

1. Push and hold the power/volume/scan control (C) to turn each speaker OFF.

You will need to hold the control for about 1.5 seconds for the speaker to

turn off.

2. Confirm that the speaker is off by verifying that the red "standby/charging"

light and the blue "tuned" light are off.

Note: If rechargeable batteries are installed (NiMH or NiCd only) and the

speakers remain plugged in via the AC power adapters, the left

"standby/charging" indicator light will glow green, even after the

speakers have been turned off, indicating that the rechargeable batteries

are being charged.

VI. Recharging the Batteries

The speaker will automatically charge the rechargeable batteries when the

batteries are installed and the speaker is plugged in with the AC power adapter.

The "standby/charging" indicator (B) will light up green to confirm that the

batteries are being charged.

Warning: The AW871 built-in charger will charge rechargeable NiMH or

NiCd batteries only. DO NOT attempt to charge any other batteries except

those specified above.

Warning: If alkaline or other non-rechargeable batteries are installed, DO

NOT plug in the speakers using the AC power adapters. This can cause the

batteries to leak and damage the speakers. Only use rechargeable batteries if

you intend to keep the speakers plugged in.

VII. More Helpful Information

i. About Fixed-Level Audio Outputs:

A fixed-level, or line-level audio output is considered ideal since it provides

an audio signal unchanged by adjustments to the audio source (stereo, etc.)

volume control.

Hint: Fixed-level audio outputs from stereo receivers/amps will typically be

designated as Tape, Tape 1, and Tape 2 outputs, or VCR audio output

connections.

These outputs are frequently marked on A/V equipment as 'TAPE OUTPUT,'

'TAPE OUT,' 'TAPE REC, or 'TAPE RECORD or REC OUT.'

Please note: Jacks labeled PHONO, CD, LD, DVD or tape or VCR playback

(PB) are INPUTS and will not work with the transmitter.