Acoustic Research AW880 빠른 설정 매뉴얼 - 페이지 5

{카테고리_이름} Acoustic Research AW880에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acoustic Research AW880 7 페이지. Wireless indoor stereo speaker

III. Adjusting the Transmitter

1. Turn ON your audio source (i.e., A/V receiver, TV, stereo, etc.) and play music at a normal listening

volume.

2. Set the channel select switch (J) on the back of the transmitter to 1, 2 or 3. The transmitter provides three

different broadcasting frequencies. In the event that you experience poor reception or interference, try

choosing a different frequency by moving the channel select switch to another position.

3. If the transmitter gets the signal from the audio source and ready, the "On" (H) on the front of the

transmitter will turn blue.

Note: If the light does not on, please check the following:

Confirm the transmitter AC power adapter (M) is securely connected.

Confirm the cable from the transmitter is securely connected to the audio source output (TV, A/V receiver,

etc.).

IV.

1. Push the power (B) to turn each speaker ON. The standby/tuned indicator light (A) will illuminate red

while the speakers are tuning to the transmitter. The standby/tuned indicator light (A) will illuminate blue,

indicating that the speakers are tuned to the transmitter, and you should hear sound coming form the

speakers.

Note: Once the speakers have tuned to the transmitter, the standby/tuned indicator light (A) will change from

"Red" to "Blue".

2. Adjust volume on each speaker as desired.

3. For stereo operation, set the left/mono/right switch (F) to "left" on the speaker located to the left of the

listener, and set the other speaker to "right" position. Set each speaker to "mono" for the best audio quality,

if you plan on using one speaker in a different room from the other.

4. The speaker will automatically retune if it loses the signal from the transmitter. However, you can also

push the power/volume/scan control to retune the speaker at any time. While the speaker is tuning, the

standby/tuned indicator light (A) will turn red. After locking onto the transmitter signal, the blue

standby/tuned indicator light (A) will come back on.

5. The transmitter has auto-cut-off function. When there is no audio signal for a prolonged period, the power

of the transmitter will be automatically cut off.

Note: Interference in the form of static and/or distortion can sometimes be heard. If this occurs, confirm the

transmitter/speaker adjustments and indicators. If the problem persists, refer to the Troubleshooting section of

this manual.

4032009REV1